Installation instructions for the screw fixed wire holder TYPE PD/A and TYPE PD/A/2

Install the screw fixed wire holder on fence posts with a pipe diameter from 38 mm to 60 mm and a wall thickness from 1.5 mm to 2.2 mm, using a self-drilling screw type PD/A - 4.8x25 mm with a countersunk head or type PD/A/2 - 4.8x25 mm with a hexagonal head.

1. Mark on the fence posts with a center punch the points where the tension wire will run.

Standard installation assumes three levels of wire:

• first – approx. 5–10 cm below the top edge of the post,
• second – halfway up,
• third – approx. 20 cm above the ground.

2. Check that all markings are in a straight line. Use a mason’s string line or a laser level for this.

3. Position the screw fixed wire holder at the marked point. Make sure the screw fixed wire holder is straight and its loop faces upward – the tension wire must always be inserted from above the screw fixed wire holder.

4. Screw the eyelet into the post using a self-drilling screw and a screwdriver. The self-drilling screw will drill through the steel and anchor itself in the post.

5. Leave a gap of approx. 4 mm between the screw fixed wire holder and the screw head. Then insert the tension wire through the eyelet loop.

6. Switch the screwdriver to torque mode (approx. 4 Nm) to avoid over-tightening.

7. Do not press the screw fixed wire holder too hard with the screwdriver – excessive tightening may damage the screw fixed wire holder by over-compressing it with the screw.

8. Repeat all steps for each intermediate fence post.

• The product should be used exclusively in accordance with its intended purpose.
• The product should not be subjected to mechanical loads other than those resulting from its normal use.
• The product should not be modified or altered – such actions may lead to loss of protective and safety properties.
• The product is not suitable for children. There is a risk of choking on small parts. Keep the product out of the reach of children, especially if it contains small components.
• Do not expose the product to open flames or high temperatures.
• Do not use the product in chemically aggressive environments (for example, in the presence of solvents, acids, or technical oils), unless specified otherwise by the manufacturer.
• Before use, check that the product does not have any cracks, deformations, or other damage. Damaged components must be replaced – products with visible defects must not be used.
• Do not modify, cut, or alter the product – this may result in the loss of its properties and increase the risk of accidents due to malfunction.
• The product is not intended for contact with food, drinking water, or direct contact with the human body, unless specified otherwise by the manufacturer.
• Clean the product with a soft, damp cloth, without aggressive detergents or solvents.
• If the product is used in or near electrical installations, ensure that it does not conduct electricity and that its use complies with electrical safety regulations.
• Dispose of the product in accordance with local regulations regarding plastic waste. Do not throw it into mixed waste if waste separation is required.
• If there are any doubts about proper use, please consult the manufacturer.
  
  Tulplast Socha sp. k.
  62-021 Paczkowo
  ul. Wiosenna 27
  
  Monday to Friday 8:00 to 16:00
  +48 61 815 70 16 
  order@tulplast.pl

We are a manufacturer with over 40 years of experience in the production of plastic and metal products. We have a large warehouse to maintain a deep inventory. Our committed customer service team will quickly handle even the biggest and most demanding orders, including custom-made orders. To ensure top-quality service to our customers, we will gladly examine your requests and prepare an attractive quote. Requests should be sent to: order@tulplast.pl